EGE-Elektronik Spezial-Sensoren GmbH - Special-Sensors for Automation

Temperature sensors - Technology and application

Functionality
The compact models TN 552 GPP and TN 552/1 GPP have two independent adjustable switching points. The compact models TN 552 GAPP and TN 552/1 GAPP have one independent adjustable switching point and one scalable 4...20 mA analog output.
The detecting range for fluids is from – 40 °C to +120 °C, the tolerance is 0.3 °C (0...80 °C).
The compact models TN 552... offer a window function as an alternative to the standard limit monitoring. Additionally, the NO/NC output function is programmable. Transient temperature changes can be bridget with a switch-on / switch-off time delay.
The push-buttons on the front of the sensor are used for programming the sensor functions. The programmed switching point and parameters are displayed and set by keyboard request. This function is possible while the sensor is measuring.

Temperature sensor with threaded sleeve allowing for
exchange during ongoing operations

The temperature sensor TN 553 can easily be exchanged during ongoing operations. This is made possible through the use of a special stainless steel (AISI 316 Ti) threaded sleeve that is mounted in the tank or pipe. In this way the compact device can at any time be removed without compromising the seal of the tank or pipe. The temperature sensor measures temperatures from – 40° to +120° C and offers, among other features, two programmable switching points, freely selectable hysteresis and a temperature window function. The device is available as a 24 V DC device with PNP or analog output as well as a 230 V and 115 V AC model with Opto-MOS. Various cable lengths and optional plug-in or hardwire connections allow the device to be installed in various configurations. The thread is a G1/2 gauge.

Installation
EGE temperature sensors can be installed in standard T-pieces or welded T-pieces. The packing is made with an additional flat seal or with other suitable materials. Please note the temperature and pressure resistance of the seals for increased process conditions. Fixing the sensor in the T-pieces is only allowed on the screw head of the sensor.
After the installation the display can be turned through an angle of 330° for best reading. In applications with temperature over +80 °C the sensor should be mounted from the side into the pipe.

Application
The hysteresis function is for controlling a temperature value. A limiting value can be programmed in this mode. As soon as the measured temperature is higher than the programmed limiting value, the output signals are switched as programmed (NC or NO). The hysteresis value is the difference temperature for the switch-on and switch-off signal of the limiting value. An additional time delay for the switching signals can be programmed for each switching point.
In the frame function mode the switching function is set depending of a programmed temperature range. The temperature range starts with the programmed lower value and end with programmed upper frame value.
The time delay for the switching signal can also be used in this switching mode.
The analog output can be use for transmitting the temperature and getting the proportional current. For that you assign one temperature for the 4 mA first-value and one temperature for the 20 mA last-value in the programming mode. Between the temperature values it is permissible to have a minimal difference of 16 °C / 29 °F.

Temperature montioring EGE

Temperature montioring EGE

Approval for safety applications
Sensors for personal security must have a qualifification approval according to EN 954-1 and must be labeled accordingly. Sensors that are not labeled must not be used for applications of this kind.

« back to overview

powered by webEdition CMS