EGE-Elektronik Spezial-Sensoren GmbH - Special-Sensors for Automation

Inductive proximity switches - Installation

Mounting
For flush mounting the sensor can be built into metal up to its active surface without changing its characteristics. For nonflush mounting a metal-free zone around the sensor must be allowed for. A free zone to the material opposite the sensor must be maintained for all sensors.

Installation proximty switches EGE

The indicated free zones are in accordance with the standard EN 60947-5-2.

Variable mounting of the sensors is possible by our assembly aids.

Collocation
When collocating the sensors, a minimum separation must be kept between the devices in order to avoid mutual influence. When in doubt, a test should be conducted under application conditions.
For flush mounting the lateral separation between two sensors must correspond to at least the diameter of the sensor. For non flush mounting, the lateral separation from one another must correspond to at least twice the diameter of the sensor. For separations greater than eight times the diameter no mutual influence is to be expected. For oppositely mounted sensors, a minimal separation of eight times the nominal switching separation should be allowed for.

Torques
In order to prevent destruction of the threaded bushing during fitting, the following maximum torques must not be exceeded:

Torque proximity switches

PTFE sensors may only be tightened by hand.

Instructions for operation

Serial connection
For the serial connection of two wire or three wire sensors the individual voltage drops are added together. Therefore there is a lesser operational voltage at the disposal of the load. The addition of the switch-on delay times should be noted.

Parallel connection
The parallel connection of two wire sensors can only be conditionally recommended since the residual currents are added together and flow through the load. For the parallel connection of three wire sensors, the current consumption of the individual devices is added together. Since this current does not flow through the load, the maximum number of parallel connectable three wire sensors depends only on the power supply.

Approval for safety applications
Sensors for personal security must have a qualifification approval according to EN 954-1 and must be labeled accordingly. Sensors that are not labeled must not be used for applications of this kind.

« back to application      forward to terminology »

« back to overview

powered by webEdition CMS